Custom Rumble Bracket for Better Aesthetics and Quality-of-life Improvements for Gamecube Controller, 3D Printed Personalized Vibration Mod

This design offers numerous improvements:
- Screw-down design won't fall off the circuit board
- Holds the rumble motor much more securely compared to the OEM design
- Much more space near the analog stick potentiometer pins for installing snapback mods
- Customizable to match any color scheme and enhance the look of your controller, especially with clear shells!

To get different colors or other mods for your controller, please take a look to our Smash Competition Mods section:
https://www.etsy.com/fr/shop/ArkatzMods?section_id=48721924

You can also find a lot more products for your GameCube controller in our shop:
https://www.etsy.com/fr/shop/ArkatzMods

This product includes:
- 1 bracket
- 2 screws to hold the bracket on the PCB

Installation:
- Insert left and right digital trigger circuit boards
- Put bracket into place and ensure it sits flush with the board (especially the “clips” at the top of the potentiometers). On some potentiometer versions the bracket may audibly “click” into place.
- Install and tighten the two mounting screws at the left and right (screws install from the front of the circuit board). While tightening, it is recommended to pull the bracket towards the “bottom” of the board so the clips are held firmly against the potentiometers.
- Install rumble motor and guide the wires through the rumble clip.
- Reassemble controller!